How to install jxd200b firmware

If your are not an audiophile and don't care much about audio/video quality, cheap chinese MP3/MP4 players are just for you, these devices are quite popular and just get the job done, since there is no quality control over these devices they do not last long, one of the most common problems faced with these portable players is the issue of firmware software corruption, I encountered a similar problem with my friends PMP which refused to start getting stuck at loading screen, the only solution was to flash the firmware but the problem was unavailability of any information and tools to get the job done, after long research and flashing the firmware I was able to successfully recover the MP4 player to working condition.


Here is an step-by-step tutorial on how to identify your MP4 player, download its firmware and flash it using appropriate tools :




WARNING : This procedure can render your device dead, so do not try if your player is working fine.


The most important step of the whole process is to correctly identify your device CONTROL CHIP and CPU, using wrong firmware or flashing tool may cause damage to your device, unscrew and open your device and write down all chip id's and motherboard numbers .

You will now need to download the correct firmware and flashing utility for your device control chip and cpu to download the firmware and flashing utility, firmware


S1FW
MyMpxPlayer
SKMP3


Once identified you need to connect your device to computer via USB in camera mode (Press R + START button and plugin USB cord on player), for Windows to identify this mode you will need camera drivers you need to point Windows Found New Hardware Wizard to Driver folder downloaded with the FRM Pro utility , this will install the first camera driver, for correct identification by flashing utility you need to install a second camera driver - open Windows Hardware Manager and install unidentified camera device drivers by pointing the driver wizard to Driver folder used earlier
to get drivers click here in this folder there are two types folder
1.Driver
2.frm pro software
just use driver folder for detecting
For firmware access this site: http://www.jxd.cc/enupload/200B.rar

Now install and launch FRM Pro flashing utility and follow this instruction to install the new firmware.



Double-click to open burning software “FRM 1.2.4.5”, then select the “Advanced” tab;
Right-click “RSV”, then select “Set Working Folder” and specify the directory where the firmware is in.








3.  Before upgrading, you need to choose FW1 and FW2, details as follows
A.  Right-click to choose firmware_1






B.  Then select “Set File” to find BootLoad.BIN, then click OK.






C.  Right-click to find firmware_2.








D．Select “Set File” to find “SPMP3062A.BIN”,  then click OK.






4.  Right-click "Working Folder" to select "Create Rsv Image", then click "OK".










5.   Back to “BASIC” tab, then select the corresponding Platform and click “ISP” to start burning.




After clicking “ISP”, the progress bar will move forward till finishing the whole updating. And if the progress bar disconnected or terminated, that means you failed to upgrade, please check your device and do it again.
After this a successful window apper

I hope you like it........
Just click ads to make money for me :)